Sensor, Crankshaft Position: Removal: 3.6L

Disconnect and isolate the negative battery cable.

Courtesy of CHRYSLER GROUP, LLC
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Remove bolts (1) and the belly pan.

Courtesy of CHRYSLER GROUP, LLC

NOTE:
The Crankshaft Position (CKP) sensor is mounted into the right rear side of the cylinder block.
Push back the heat shield (1) from the crankshaft CKP sensor.
If equipped with All Wheel Drive (AWD) you must remove the front propeller shaft to gain access to the CKP. Refer to REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
Disconnect the CKP sensor wire harness connector (1).

Courtesy of CHRYSLER GROUP, LLC
Remove bolt (2) the CKP sensor (1) from the cylinder block.