Sensor, Air Temperature, Inlet: Removal: 3.6L

Fig 1: Negative Battery Cable

Courtesy of CHRYSLER GROUP, LLC

1. Disconnect and isolate the negative battery cable (1).
   Fig 2: Engine Cover

   Courtesy of CHRYSLER GROUP, LLC
2. Lift the engine cover retaining grommets off the ball studs and remove the engine cover (1).
   Fig 3: Inlet Air Temperature Sensor Electrical Connector

   Courtesy of CHRYSLER GROUP, LLC
3. Disconnect the electrical connector (1) from the Inlet Air Temperature (IAT) sensor.
   Fig 4: IAT Sensor Tab/O-Ring

   Courtesy of CHRYSLER GROUP, LLC
4. Clean any dirt from the air inlet tube at the IAT sensor base.
5. Gently lift the small plastic release tab (3), rotate the sensor about 1/4 turn counterclockwise and remove the sensor from the inlet air hose.
6. The IAT sensor O-ring (2) can be reused if not damaged.