Sensor, Manifold Air Pressure (Map): Installation: 3.6L

Fig 1: O-Ring

Courtesy of CHRYSLER GROUP, LLC

1. The manifold air pressure (MAP) sensor O-ring (1) can be reused if not damaged.
2. Apply a small amount of engine oil to the sensor O-ring (1).
   Fig 2: MAP Sensor And Rotate 1/4 Turn Clockwise

   Courtesy of CHRYSLER GROUP, LLC
3. Install the MAP sensor (1) into the upper intake manifold and rotate 1/4 turn clockwise.
   Fig 3: MAP Sensor Electrical Connector

   Courtesy of CHRYSLER GROUP, LLC
4. Connect and lock the electrical connector (1) to the sensor.
   Fig 4: Engine Cover

   Courtesy of CHRYSLER GROUP, LLC
5. Position the engine cover (1) and secure the retaining grommets onto the ball studs.
   Fig 5: Negative Battery Cable

   Courtesy of CHRYSLER GROUP, LLC
6. Connect the negative battery cable and tighten nut to 5 N.m (45 in. lbs.).