LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2012 >> 300 C, 4WD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Vehicle Theft Security (Service Information) >> Module, Shaft Lock >> Installation >> Installation

Module, Shaft Lock: Installation: Installation

NOTE:

Before attempting service, the ignition key must be inside the vehicle near or on the center console for the entire length of the procedure.

Fig 1: Module Area & Column Lock Shaft Area
GC0144903Courtesy of CHRYSLER GROUP, LLC
  1. Check and remove any debris found the column lock shaft area (1).
  2. Check the rest of the module area (2) for debris that will prevent the column lock module from function properly.
  3. Push in the threaded stud on the steering column lock module and install the steering column lock module into the steering column.
    Fig 2: Steering Column Lock Module Retainer & Steering Column Lock Module Jumper Harness
    GC0144899Courtesy of CHRYSLER GROUP, LLC
  4. Install the steering column lock module jumper harness (1).
  5. Install the steering column lock module retainer (2).

    Tighten to 6 N.m (53 in. lbs.).

  6. Install the steering column. Refer to COLUMN, INSTALLATION .
  7. Connect the negative battery cable/IBS to the battery.
NOTE:

If a NEW column lock module has been installed, a new Radio Frequency Hub (RF Hub) must also be installed.

NOTE:

Program the modules as described in the "RF-Hub, BCM, PCM FOBik and ELV Replacement and Programming Order Guide". Refer to STANDARD PROCEDURE .

NOTE:

For additional information programming the ELV/ESCL. Refer to STANDARD PROCEDURE .

scientia non olet · About LEMON Manuals