LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Orlando LS, Standard Trans >> Repair and Diagnosis >> Steering >> Manual Steering >> Power Steering System >> Repair Instructions >> Power Steering Gear Inlet Pipe/Hose Replacement >> Removal Procedure

Removal Procedure

  1. Remove front bumper fascia. Refer to Front Bumper Fascia Removal and Installation .
  2. Remove as much power steering fluid from the remote power steering fluid reservoir as possible.
  3. Place drain pans under the vehicle as needed.
    4. Fig 1: Inlet Hose And Clip
    GM2189284Courtesy of GENERAL MOTORS COMPANY
  4. Remove power steering gear inlet hose bolt (1).
  5. Remove inlet hose (3) from clip (2).
    6. Fig 2: Hollow Screw
    GM2538047Courtesy of GENERAL MOTORS COMPANY
  6. Unscrew hollow screw (1).
  7. Remove and DISCARD washer (2).
  8. Remove inlet pipe (3) from power steering pump.
    9. Fig 3: Power Steering Gear Inlet Pipe
    GM2503253Courtesy of GENERAL MOTORS COMPANY
  9. Unscrew 3 bracket nuts (1).
  10. Remove power steering gear inlet pipe (2) from vehicle.
  11. Extract the steering gear oil seal from the steering gear.
scientia non olet · About LEMON Manuals