LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Impala Police >> Repair and Diagnosis >> External Pages >> Different car >> Section 1037 (Engine Controls And Fuel - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Mass Airflow Sensor/Intake Air Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of MAF/IAT Sensor
    GM1837985Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW MAF/IAT sensor seal.
  2. Install the MAF/IAT sensor.
    3. NOTE: Refer to Fastener Notice .
  3. Install the MAF/IAT sensor screws.

    Tighten:  Tighten the screws to 4 N.m (35 lb in).

    4. Fig 2: View Of MAF/IAT Sensor Wiring Harness Connector
    GM1838957Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness electrical connector to the MAF/IAT sensor.
  5. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
scientia non olet · About LEMON Manuals