LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Impala Police >> Repair and Diagnosis >> External Pages >> Different car >> Section 1037 (Engine Controls And Fuel - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Level Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Fuel Tank Module Assembly Components
    GM1796305Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank module assembly. Refer to Fuel Tank Module Replacement .
  2. Remove the fuel level sensor wiring harness from the clip (2) on the module.
  3. Disconnect the fuel level sensor electrical connector from the pump module electrical connector.
  4. Push the tab (1) on the sensor in towards the sensor and remove the level sensor from the module alignment feature (3).
scientia non olet · About LEMON Manuals