Test Description
The number below refers to the step number on the diagnostic table.
- 2: This test confirms that the condition exists in the SSPS system and not in the electrical system.
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
| Schematic Reference: Power Steering Schematics Connector End View Reference: Component Connector End Views |
||||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
4.8-5.2 V | Go to Step 3 | System OK |
| 3 | Test for an open or poor connection on the ground circuit of the speed sensitive power steering (SSPS) control module. Refer to Testing for Continuity
and Wiring Repairs
. Did you find and correct the condition? |
- | Go to Step 7 | Go to Step 4 |
| 4 | Test for an open or poor connection on the ignition circuit of the SSPS control module. Refer to Testing for Continuity
and Wiring Repairs
. Did you find and correct the condition? |
- | Go to Step 7 | Go to Step 5 |
| 5 | Test for a poor connection at the SSPS control module. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
- | Go to Step 7 | Go to Step 6 |
| 6 | Replace the power steering control module. Refer to Power Steering Control Module Replacement . Is the repair complete? |
- | Go to Step 7 | - |
| 7 | Operate the system in order to verify the repair. Did you correct the condition? |
- | System OK | Go to Step 2 |