LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 524 (Wheel Alignment System) >> Repair Instructions >> Rear Camber Adjustment >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the strut to the vehicle. Refer to Strut Assembly Replacement .

    Tighten:  Tighten the strut-to-knuckle bolts as far as to allow movement of the knuckle.

    Fig 1: Identifying Rear Camber Adjustment
    GM156938Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
  3. Adjust the camber (1).

    Tighten:  Tighten the strut-to-knuckle bolts to 120 N.m (89 lb ft).

  4. Lower the vehicle.
scientia non olet · About LEMON Manuals