Circuit/System Testing
WARNING: This page is about a different car, the 2007 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the rearview mirror.
- Test for less than 3 ohm of resistance between the ground circuit and ground.
- If greater than 3 ohm, test the ground circuit for an open/high resistance.
- Ignition ON, verify that a test lamp illuminates between the voltage supply circuit and ground.
- If the test lamp does not illuminate, repair the voltage supply circuit for a short to ground or an open/high resistance.
- With the transmission in PARK, test for 0.5 volt between the backup lamp supply voltage circuit and ground.
- If the voltage is greater than 0.6 volt, test the backup lamp supply voltage circuit for a short to voltage.
- With the transmission in REVERSE, test for battery voltage between the backup lamp supply voltage circuit and ground.
- If the voltage is not 12 volts, test the backup lamp supply voltage circuit for an open/high resistance.
- If all circuits test normal, replace the rearview mirror.