Theft Deterrent System
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Diagnostic Starting Point - Theft Deterrent
- Diagnostic System Check - Theft Deterrent
- Scan Tool Data Definitions
- DTC B2947: Short To Ground On The Passlock™ Sensor Power Circuit
- DTC B2948: Security Sensor Signal Circuit Voltage
- DTC B2957: BCM Signal Input Voltage Low
- DTC B2958: BCM Signal Input Voltage High
- DTC B2960: Valid But Different Code Value Than Previously Learned Form Passlock™ Sensor
- DTC B3031: BCM Does Not See A Valid Passlock™ Sensor Code
- DTC B3033: BCM Is Reading A Tamper Code From The Passlock™ Sensor
- DTC P1626: PCM To BCM Communication
- DTC P1631: PCM Did Not Receive A Valid Password
- DTC P1632: Undecided Password Was Sent From BCM
- Symptoms - Theft Deterrent
- Repair Instructions
- Description and Operation
- Theft Systems Description and Operation
- Content Theft Deterrent (CTD) Description and Operation
- Content Theft Deterrent (CTD) System
- SECURITY Telltale
- Body Control Module (BCM)
- Door Latch, Door Jamb Switches
- Door Key Switch
- Remote Control Door Lock Receiver Module System
- Off State
- Idle State
- Disarmed State
- Ready-To-Arm State
- Arm Initiated State
- Arm Delay State
- Armed State
- Alarmed State
- Remote Panic Alarm/Vehicle Locator State
- Locking the Vehicle Without Arming the System
- Disarming the System
- Deactivating the Alarm
- Alarm State Activation
- Return System to Arm Initiated State
- Ignition Switch Disarm Function
- Vehicle Theft Deterrent (VTD) Description and Operation
- Special Tools and Equipment