Circuit/System Verification
- Ignition ON/Vehicle in Service Mode.
- Verify no other DTCs are set.
- If any other DTCs are set
- Go to next step: If no other DTCs are set
- Verify DTC P0602 is not set.
- If the DTC is set
- Perform all necessary programming and setup procedures for K160 Brake System Control Module.
- Verify the DTC does not set.
- If the DTC sets, replace the K160 Brake System Control Module.
- Go to next step: If the DTC does not set
- All OK.
- Go to next step: If the DTC is not set
- All OK