Removal Procedure
WARNING: This page is about a different car, the 2006 GMC Sierra, 2006 GMC Cab & Chassis Sierra, 2006 Chevrolet Silverado, and 2006 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Remove the stabilizer shaft links from the lower control arm. Refer to Stabilizer Shaft Replacement .
- Remove the shock absorber lower nut and the bolt. Refer to Shock Absorber Replacement (RWD) or Shock Absorber Replacement (4WD) .
- Remove the torsion bars. Refer to Torsion Bar Replacement .
- Remove the wheel drive shaft. Refer to Wheel Drive Shaft Replacement in Wheel Drive Shafts.
- Remove the lower ball joint retaining nut.
- Disconnect the lower ball joint stud from the steering knuckle using J 43631 and J 45851 . See Special Tools .
- Remove the lower control arm nuts and the 15-series washers.
- Remove the lower control arm bolts.
- Remove the lower control arm nuts and the 25/35-series washers.
- Remove the lower control arm bolts.
- Remove the lower control arm.