13 62 010 Removing and installing/replacing fuel differential pressure sensor (N52T)

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Unclip wiring harness (1) and lay to one side.

Unlock connector (2) and remove.

Release screws (3).

Tightening torque 13 62 4AZ .

Pull differential pressure sensor (4) out of intake plenum.

Fig 1: Identifying Differential Pressure Sensor, Connector And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Read out fault memory of control unit of Digital Engine Electronics (DME).

Check stored fault message.

Delete fault memory.