27 00... Replenishing/changing transfer box oil (ATC 700)
IMPORTANT:
Use only the approved gear oil in the transfer box.
Failure to comply with this requirement will result in serious damage to the transfer box! See TRANSFER BOX - OPERATING FLUIDS .
Failure to comply with this requirement will result in serious damage to the transfer box! See TRANSFER BOX - OPERATING FLUIDS .
NOTE:
Only change the oil when the transfer box is at normal operating temperature.
Necessary preliminary tasks:
- Remove UNDERBODY PROTECTION .
- If necessary, remove EXHAUST SYSTEM .
- Remove heat shields.
Checking/correcting transfer box oil level:
Undo oil filler plug (1).
Check transfer box oil level.
If necessary, pour in gear oil up to lower edge of opening for oil filler plug (1).
Installation:
Tightening torque 27 00 11AZ .
Replace sealing ring.
Changing transfer box oil:
Place oil collecting apparatus underneath.
Remove oil drain plug (1).
Drain and dispose of gear oil.
NOTE:
Observe country-specific waste-disposal regulations
Replace sealing ring, screw in oil drain plug (1) and tighten down.
Tightening torque 27 00 11AZ .
Undo oil filler plug (1).
Pour in gear oil up to lower edge of opening for oil filler plug (1).
Tightening torque 27 00 11AZ .
Replace sealing ring.