Remove & Install or Remove & Replace
WARNING: This page is about the RS 7 Base, which is a different variant/trim than selected.
NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Both | 2.2 | B | ||
| One Side | 1.5 | B | ||
| Combination Procedure: AXLE SHAFT: Replace: NOTE: For Independent Suspension Type Axles, this operation consists of dissassembly and reassembly of the Axle Shaft Assembly and replacement of the Axle Shaft. | ||||
| Each Side | 0.9 | B | ||
| Combination Procedure: AXLE SHAFT BOOT: Remove & Replace: | ||||
| Both,One Side | 0.9 | B | ||
| One,Inner or Outer | 0.6 | B | ||
| Combination Procedure: CONSTANT VELOCITY JOINT: Remove & Replace: | ||||
| Both,One Side | 0.9 | B | ||
| One,Inner or Outer | 0.6 | B | ||
| Combination Procedure: DIFFERENTIAL OUTPUT FLANGE: Remove & Replace: | ||||
| Left Side | Refer to Differential Output Flange - R&R standalone operation. | B | ||
| Right Side | 0.1 | B | ||
| Combination Procedure: DIFFERENTIAL OUTPUT SEAL: Remove & Replace: | ||||
| Left Side | Refer to Differential Output Seal - R&R standalone operation. | B | ||
| Right Side | 0.3 | B | ||