Body, rear
Courtesy of VOLKSWAGEN UNITED STATES, INC.
- A = As in original joint, apply adhesive and bead over edge of wheel housing. If the adhesive bond is damaged, re-work as follows:
- Brush area, restore paint structure and apply cavity sealing. If the adhesive bond is damaged over a length of more than 100 mm, make a 10 mm SG seam every 50 mm. Re-work wheel housing liner if necessary.
- B = Rear wheelhousing liner to rear wheel housing, make additional 4 x 30 mm SG seam.
- C = Rear wheelhousing liner to rear floor, RP spot weld seam with double the number of welds.
- D = Rear longmember to rear wheelhousing, RP spot weld seam with double the number of welds.
- E = Rear wheelhousing liner to rear wheelhousing RP spot weld seam with 25 mm spacing.
- F = Rear wheelhousing liner to rear wheelhousing, make 2 additional spot welds.
- G = Install replacement part taillight mount to rear cross panel. In place of bonded joint make 3 x SG plug weld seam.
Courtesy of VOLKSWAGEN UNITED STATES, INC.