LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2002 >> A4 Base, 1.8 C, Standard >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Specifications & Procedures >> Wheel Alignment Procedures >> Camber Adjustment (Rear)

Camber Adjustment (Rear)

NOTE: Before attempting any adjustments, see PRELIMINARY CHECKS  and WHEEL ALIGNMENT PROCEDURES  .
NOTE: Manufacturer recommends using NEW nut if original is loosened or removed.
  1. Unfasten nut from wheel bearing housing/transverse link bolted joint (A). Adjust camber by turning eccentric bolt (B). See Fig 1 . See WHEEL ALIGNMENT SPECIFICATIONS  . Maximum adjustment range is 90 to left or right from center position.
  2. Fasten NEW nut. Tighten to 70 ft. lbs. (95 N.m). Recheck camber adjustment after tightening nut.
Fig 1: Adjusting Rear Camber
G00283686Courtesy of AUDI OF AMERICA, INC.
scientia non olet · About LEMON Manuals