TCM Inspection
NOTICE:
Before disconnecting the TCM connector, jump the SCS line with the HDS, and wait more than 1 minute.
NOTE:
Since there is no direct method to test the component itself, troubleshooting is performed on the related components.
Test Procedure
- Preparation
-
- -
TCM connector (50P): disconnected
- -
- Procedure
-
- -
Perform the inspection according to the following table.
- -
(Disconnected) TCM connector (50P) female terminals
IG Mode
Normal Conditions
Solenoid internal circuit inspection
OFF
10.6-13.5 Ω
Results
- If it is normal, there is a problem with the TCM.
- If it is abnormal, there is a problem with other related components.