Navigation Display Visor Removal/Installation

WARNING: This page is about a different variant/trim than selected.

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or service,

NOTE:

Do this procedure in a clean place free from dirt.
Wear latex or vinyl gloves when doing this procedure (Do not use fabric gloves).
When removing the navigation display visor, do not touch the scale plate.
If there is dirt on the scale plate, clean it using compressed air.
When installing the navigation display visor onto the LCD assembly, be careful not to touch the scale plate.
Check that the navigation display visor and the LCD assembly are properly installed.
Since the LCD assembly and the navigation display visor are installed at an angle, be sure that the screws are properly seated. If not properly seated, tighten the screws.
Check that the navigation display unit assembly has no damage.

Remove the navigation display unit (see NAVIGATION DISPLAY UNIT REMOVAL/INSTALLATION ).
Remove the passenger's airbag cutoff indicator (see INSTALLATION ).
Remove the screws (A) from the LCD assembly (B).

Fig 1: Locating Screws From LCD Assembly
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the display visor (A) from the LCD assembly (B).

Fig 2: Locating Display Visor And LCD Assembly
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the navigation display visor in the reverse order of removal.