LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2012 >> RL >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Keyless Entry/Power Door Locks/Security System >> Door Lock Knob Switch Test >> Driver's Door

Driver's Door

  1. Remove the driver's door panel. See FRONT DOOR PANEL REMOVAL/INSTALLATION .
  2. Disconnect the 10P connector (A) from the actuator (B).
    Fig 1: Disconnecting 10P Connector From Actuator
    G07354894Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Check for continuity between the terminals.
    • There should be continuity between terminals No. 6 and No. 5 when the door lock knob switch is in the LOCK position and no continuity when the switch is in the UNLOCK position.
    • There should be continuity between terminals No. 7 and No. 5 when the door lock knob switch is in the UNLOCK position and no continuity when the switch is in the LOCK position.
  4. If the continuity is not as specified, replace the door latch. See FRONT DOOR LATCH REPLACEMENT .
scientia non olet · About LEMON Manuals