DTC U1280: Communication Bus Line Error (BUS-OFF)
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A
- Clear the DTCs with the HDS.
- Turn the ignition switch to LOCK (0) and then back ON (M).
- Wait for more than 6 seconds.
- Check for DTCs with the HDS.
Is DTC U1280 indicated?
YES -Go to step 5.
NO -Intermittent failure, the system is OK at this time. Check for loose or poor connections at the MICU and B-CAN connected units in the table.
Under-dash fuse/relay box connector B-CAN connected unit connector Connector N (45P) terminal No. 28 HandsFreeLink control unit 28P connector terminal No. 18 Connector G (6P) terminal No. 1 AcuraLink control unit (XM receiver) connector A (32P) terminal No. 10 Connector G (6P) terminal No. 1 BSI control unit 16P connector terminal No. 5 - Check for DTCs with the HDS.
Is DTC B1000 also indicated?
YES -Troubleshoot DTC B1000.
NO -Intermittent failure, the system is OK at this time. Check for loose or poor connections at the MICU and B-CAN connected units in the table.