Rear Controller And Screen 24P Connector

Fig 1: Identifying 24P Connector Terminals

Courtesy of AMERICAN HONDA MOTOR CO., INC.

REAR CONTROLLER AND SCREEN 24P CONNECTOR

Cavity	Wire Color	Terminal Name	Connect to
1	WHT	+ B	No. 7 (10 A) fuse in the under-dash fuse/relay box
2	YEL	IG1	No. 21 (7.5 A) fuse in the under-dash fuse/relay box
3	LT BLU	GA-NET RR BUS +	Audio-Navigation unit
5	PNK	RR NTSC GND	Audio-Navigation unit
6	WHT	RES AUDIO OUT GND	Audio-Navigation unit
7	BRN(1)	RES AUDIO OUT SH	Shield for terminals No. 6, No. 18, and No. 19
8	PNK	HP R/L OUT GND	RES auxiliary jack assembly
9	BRN(1)	HP R/L OUT SH	Shield for terminals No. 8, No. 20, and No. 21
10	GRY	SCTY1	Multiplex integrated control unit
11	LT BLU	ILLUMI+ (INT)	Interior light relay (Lights-on signal)
12	YEL	SYSTEM ACC	Audio-Navigation unit
13	BRN(1)	GA-NET RR BUS SH	Shield for terminals No. 3 and No. 14
14	PUR	GA-NET RR BUS-	Audio-Navigation unit
16	BLU	RR NTSC	Audio-Navigation unit
17	BRN(1)	RR NTSC SH	Shield for terminals No. 5 and No. 16
18	RED	RES AUDIO OUT L	Audio-Navigation unit
19	BLK	RES AUDIO OUT R	Audio-Navigation unit
20	GRN	HP LOUT	RES auxiliary jack assembly
21	BLU	HP R OUT	RES auxiliary jack assembly
22	PNK	SCTY3	Navigation display unit
23	RED	ILLUMI- (SW/RES)	Dash lights brightness control circuit in the gauge control module
24	BLK	GND	Body ground to G506
(1) The shielded wires have a heat-shrink tube insulating the outside of the wire. The color of the insulating tube, typically black or dark gray, may not match the color of the wire listed on the schematic.