LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2002 >> RSX Base, Automatic >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Automatic Transmission >> General Troubleshooting Information >> 2002-2004 Models >> How to End a Troubleshooting Session

How to End a Troubleshooting Session

This procedure must be done after any troubleshooting.

  1. Turn the ignition switch OFF.
  2. Reset the PCM using one of these methods:
    • Use the Scan Tool or the HDS, then disconnect the Scan Tool or the HDS from the DLC.
    • Disconnect the Scan Tool or the HDS from the DLC, then reset the PCM by removing the No. 6 ECU fuse in the underhood relay/fuse box for more than 10 seconds.
      NOTE: After resetting the PCM, do the PCM idle learn procedure (see ECM/PCM IDLE LEARN PROCEDURE ).
  3. To verify that the problem is repaired, test-drive the vehicle for several minutes at speeds over 30 mph (50 km/h) or in freeze data range.
scientia non olet · About LEMON Manuals