LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2000 >> Integra GS-R, 4D Sedan >> Repair and Diagnosis (Single Page) >> Maintenance >> Maintenance Reminder Light (Reset Procedures) >> Tire Pressure Monitor System Reminder >> TPMS Reminder Reset - Procedure 01 >> Memorizing Sensors IDs Automatically

Memorizing Sensors IDs Automatically

  1. Select Sensor ID Learning from the Mode Menu on the HDS.
  2. Follow the HDS screen prompts to turn on the TPMS tool.
  3. Hold the TPMS tool (A) near the valve stem of one wheel, and memorize the tire pressure sensor ID by following the screen prompts on the HDS.
    NOTE:
    • If you press the engine start/stop button to select the OFF mode before memorizing all four sensor IDs, the memorizing sensor ID is canceled.
    • If more than one sensor ID is displayed on the HDS, verify that the vehicle has not been driven for 5 minutes, and there are no other vehicles or tire pressure sensors within 10 ft (3 m).
    • See the HDS Help menu for specific instructions.
  4. Repeat step 3 for each wheel until all four sensor IDs are memorized. When all four IDs are memorized, the low tire pressure/TPMS indicator blinks.
  5. Press the engine start/stop button to select the OFF mode.
  6. Disconnect the HDS from the DLC.
  7. Test-drive the vehicle at 28 mph (45 km/h) or more for at least 3 minutes.
  8. Make sure the low tire pressure/TPMS indicator does not blink.
  9. Make sure the tires are inflated to the specified tire pressure listed on the doorjamb label.
  10. Press the engine start/stop button to select the OFF mode.
scientia non olet · About LEMON Manuals