Removal (Rear)
- Remove door panel and plastic cover. See DOOR PANEL
. On 3.5RL, remove inner window molding and inner sash trim. On all models, ensure power window switch is connected. Raise power window glass until mounting bolts are visible. Remove screw, release hooks and protector. Using a grease pencil, mark original adjustment position of stopper plates.
- Mark original position of glass mounting bolts. Push glass against center channel. Remove bolts and collar from rear channel. Pull sub-seal away to reveal and remove screw. Pull glass run channel away as needed from rear channel. Move rear channel away from quarter glass and rear door glass. Ensure not to damage door molding.
- Remove rear channel out through window slot. Remove quarter glass. Remove bolts and carefully slide glass out through window slot. Disconnect electrical connector and harness clip from door. Loosen power window motor and regulator mounting bolts "A". See Fig 1
. Remove power window motor and regulator mounting bolts "B". Remove power window motor and regulator through hole in door. Remove power window motor from regulator.
Courtesy of AMERICAN HONDA MOTOR CO., INC.