LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 1996 >> 2.5TL >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> A/C-Heater System - Automatic >> Testing >> Air Mix Control Motor Test

Air Mix Control Motor Test

  1. Disconnect 5-pin connector from air mix control motor. Connect battery voltage to air mix control motor terminal No. 1 and ground terminal No. 5. See Fig 1 . If air mix control motor does not run and stop at HOT position, reverse battery connections. If air mix control motor does not run and stop at COOL position, remove air mix control motor.
    NOTE: If air mix control motor does not run, remove air mix control motor. Check doors and linkage for smooth operation. If doors and linkage are okay, air mix control motor must be replaced.
  2. Measure resistance between terminals No. 2 and No. 3. Resistance should be approximately 4800-7200 ohms. Measure resistance between terminals No. 3 and No. 4. Resistance should be approximately 960-1440 ohms at maximum HOT position, and approximately 3840-5760 ohms at maximum COOL position. If resistance checks are not as specified, replace air mix control motor.
Fig 1: Identifying Air Mix Control Motor Terminals
G95J60607Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals